Photo by Melody

Australian and New Zealand Gardening: BROMELIADS FOR EVERYONE IN 2014, 2 by 77sunset

Communities > Forums

Image Copyright 77sunset

In reply to: BROMELIADS FOR EVERYONE IN 2014

Forum: Australian and New Zealand Gardening

Back to postNext photo >>>
Photo of BROMELIADS FOR EVERYONE IN 2014
77sunset wrote:
Good morning , its 8C here at the moment.
Thankfully the very strong winds have gone ( for a while anyway)
Its been time for heaters and electric blankets.
That will sound silly to those up north.

We will get a few warn days again by the end of the week. The rain wasnt very much so I am back to watering the pot plants.

My broms will be wondering why I have them outside in the cold...lol

I must get a pic of my neo Gezpacho later as I notice it has a large bud in the middle.
I have not seen this on any other broms. Usually, I miss any of the small buds until they open.
This one seems to be just a very large single bud.

Ian, your bills are lovely.
There is something very attractive about the spotty ones.
Hallelujah was my introduction to the world of pretty bills.

Colleen, maybe I should come over and relocate a few of your broms ....lol

Nev, thanks for the hints on deleafing. I remembered your tips from a previous thread.
I will get to them as soon as the weather gets a bit warmer.
My aech nudicaulis are looking very nice and I would love to have one of aequalis when you have a spare pup , please Nev.

Just read your last post, Nev. I too, use a very fine mist spray on hot days. Always have done with my plants, as I feel better when I get a cool shower in the heat, so plants must too.

Time I went out and fed the maggies. I can hear them squabbling at the back door.
Worse than having children around, but very entertaining with their antics.

Get well wishes for anyone not feeling 100%.
My hubby is certainly looking better after the little bit of a relapse last week.


pic 1....I am using hubbys soft drink bottles for my tills.

pic2... neo Fairy Tale

pic 3...neo Tunisia

keep safe
Jean



This message was edited Jan 6, 2014 8:07 AM